How the deadzone test works
- Let go for 2 seconds.The test measures how much the stick wanders while nobody touches it. That sets the smallest inner deadzone that hides it.
- Push slowly from the center to the edge.Take about 4 seconds. If the reading stays at zero for a while and then jumps, your controller already has a deadzone built in.
- Turn once around the edge.This shows how far the stick reaches in every direction, and whether it ever gets to a full 1.00.
Inner and outer deadzone
Inner deadzone
A small area around the center where the game ignores the stick. Too small, and drift or jitter moves your character. Too big, and small aiming movements disappear.
Built-in deadzone
Some controllers and drivers already ignore the first part of the stick's travel. If yours does, the game doesn't need much of an inner deadzone of its own.
Outer deadzone
The point near the edge where the game treats the stick as fully pushed. If your stick only reaches 0.93, an outer deadzone of 0.93 lets you hit full speed anyway.
Using the numbers in a game
Games name and scale these settings differently. Look for something like this:
| In the game's settings | Enter |
|---|---|
| Deadzone, inner deadzone, stick deadzone | The suggested inner deadzone. If the scale is 0–100, a reading of 0.04 is about 4. |
| Outer deadzone, max input threshold | The suggested outer deadzone, when it's below 1.00. |
| Separate left and right settings | Test each stick and enter each one's own value. |
If a stick needs an inner deadzone above 0.10, it's drifting. Run the stick drift test →
Related tests
FAQ
What deadzone should I use?
The smallest one that stops the stick from moving on its own. The test suggests that value from how much your stick wanders at rest.
Is a smaller deadzone always better?
Smaller means finer control, but only down to the point where drift and jitter start leaking through. Below that, the game reacts to movements you never made.
Why does my controller already have a deadzone?
Some controllers and drivers ignore the first bit of stick travel to hide small wobbles. You'll see it as a flat start and a jump on the slow push chart.
Does a deadzone fix stick drift?
It hides mild drift, but doesn't repair it. If the drift keeps growing, see how to fix stick drift.
Why doesn't my stick reach 1.00?
Wear, dirt or a worn stick module can stop it a little short of the edge. Setting the outer deadzone to your lowest reach gets you full speed back.