Stick Drift Test

Find out whether your controller's sticks drift. Let go for 3 seconds and get a pass, warn or fail for each stick, plus the deadzone that would hide it in games.

P1
No controller yet Press any button on your controller to start
Waiting for input
A

Connect a controller and press any button

Plug it in with a USB cable or pair it over Bluetooth. Browsers keep controllers hidden until you press a button, so the test is ready the moment you do.

Controller not detected? →

Left stick

No input
0.10 0.25
Zoomed in · edge = 0.30
0.000live distance
X
+0.000
Y
+0.000
Angle
—

Right stick

No input
0.10 0.25
Zoomed in · edge = 0.30
0.000live distance
X
+0.000
Y
+0.000
Angle
—

Distance from center last 20 seconds

LeftRight
0.30+ 0.25 0.10 0
20 s agonow

Leave this running for a while after moving the sticks. Some worn sticks only drift for a moment, then settle.

How the drift test works

  1. Let go of both sticks.Set the controller down so nothing touches them. Flick each stick once first, so it settles where it naturally rests.
  2. Hold still for 3 seconds.The tester keeps reading where each stick sits. Each dot on the plot is one reading.
  3. Get a verdict for each stick.You get a pass, warn or fail from the typical resting distance, plus the smallest in-game deadzone that would hide the drift.

Reading your result

The main number is the resting distance: how far the stick sits from the center when you aren't touching it, from 0 (dead center) to 1 (pushed all the way).

Resting distanceResultWhat it means
under 0.10PassNormal. Most sticks rest a few hundredths off center.
0.10 – 0.25WarnYou may notice it in games with a small deadzone.
0.25 and upFailLikely to cause drift in most games.

Resting distance

The median of every reading taken during the 3 seconds. Using the median means one small twitch doesn't change the verdict.

Spread

How much the reading wanders while the stick is still. A wide spread with a small resting distance usually points to a jittery sensor rather than a stick stuck off center.

Deadzone to hide it

The smallest in-game deadzone, with a little margin, that would stop a game from seeing this drift. Games use different deadzone scales, so treat it as a starting point.

Drift that comes and goes

If a stick passes but you still see drift in games, move it around, let go, and watch the chart for 20 to 30 seconds. Some worn sticks only drift right after they've been pushed.

Every limit and formula is published. See how we test →

What causes stick drift

Most controller sticks measure their position with small sensors that wear with use. As they wear, or as dust works its way in, the stick reports a position slightly off center even when you let go. Weak return springs can do the same.

Sticks that use Hall effect sensors measure position with magnets instead of contacts, so they don't wear the same way.

How to fix stick drift

Start with the quickest fix and work down the list.

  1. Raise the in-game deadzone. The fastest fix for mild drift. Use the suggested value above as a starting point. Deadzone test →
  2. Clean around the stick. Short bursts of compressed air around the base while you move the stick in circles.
  3. Recalibrate. Some systems and apps can recalibrate the sticks. This helps when the center is off but the sensor itself is fine.
  4. Replace the stick module. A worn sensor won't recover. Replacement sticks, including Hall effect ones, exist for many controllers.
  5. Use the warranty. If the controller is still covered, copy the share link and include it with your claim.

Full guide: How to fix stick drift →

Drift test by controller

Related tests

FAQ

What counts as stick drift?

Drift is when a stick reports movement while you aren't touching it. On this tester, a resting distance of 0.10 or more counts as drift.

Why does my stick pass here but drift in games?

Some drift only shows up right after the stick has moved, or only now and then. Flick the stick, let go, and watch the chart for a while. A game with a very small deadzone can also pick up drift that's under our limit.

Can the result be wrong?

If anything touches the sticks during the 3 seconds, the result will be off, so run it again with the controller lying flat. Software such as Steam Input can also change what the browser sees.

Does stick drift get worse over time?

It often does, because the sensor keeps wearing. Testing every few weeks shows you whether the number is creeping up.

Can I test drift on my phone?

Yes. Pair the controller with your phone over Bluetooth and open this page in Safari or Chrome, not inside another app's browser.